Skip to main content

Wireguard

Wireguard

To use Wireguard inside of a LXC container the host has to have Wireguard installed since LXC guests are run with the kernel of the host system. Additionally you'll want the wireguard-tools package in the LXC guest.

Route Subnet Through Wireguard Interface

Funneling all traffic from an Ethernet interface through a Wireguard interface is relatively easy once you're familar with how packets flow through Linux. You'll mostly just need to modify your Wireguard *.conf file to add the Table, PostUp, and PreDown parameters.

You also need to setup IP masquerading of outgoing traffic on your Wireguard interface. See below for instructions.

[Interface]
PrivateKey = ****
Address = 192.168.0.5/28
Table = 9
PostUp = ip rule add iif eth1.9 lookup 9
PreDown = ip rule del iif eth1.9 lookup 9

[Peer]
AllowedIPs = 0.0.0.0/0
...

Line 4: All rules/routes should be applied to a custom route table 9. If you want to name your custom route table you could do echo "9 warp" > /etc/iproute2/rt_tables and then say Table = warp for improved readability.

Line 5: Add a rule that all traffic coming in interface eth1.9 should use custom route table 9. Because you defined a peer with AllowedIPs = 0.0.0.0/0 a default route will be setup on custom route table 9 that redirects all traffic to the Wireguard interface. If you named your custom route like shown above you can say lookup warp inplace of lookup 9.

Line 6: Just the inverse of line 5 to clean up after ourselves when taking down the Wireguard interface.

Setup IP Masquerading

IP Masquerading is a technique that hides an entire IP address space, usually consisting of private IP addresses, behind a single IP address in another, usually public address space.

Source: Wikipedia

How To

The easiest way to set this up are to append some netfilter rules to the PostUp and PreDown parameters.

...
PostUp = ...; iptables -t nat -A POSTROUTING -o wg0 -j MASQUERADE
PreDown = ...; iptables -t nat -D POSTROUTING -o wg0 -j MASQUERADE

[Peer]
...

Although this works you risk the iptables/netfilter rules getting squashed by Shorewall when if it is restarted while the Wireguard interface exists. It is best to have Shorewall setup the masquerading by making a simple declaration in /etc/shorewall/snat. I've included the other shorewall configuration files that would be necessary to make this setup work.

This tells Shorwall to masquerade all IPs going out on WG_IF…

# /etc/shorewall/snat
  #ACTION		SOURCE		DEST
+ MASQUERADE	0.0.0.0/0	WG_IF

Then we define WG_IF…

# /etc/shorewall/interfaces
  #ZONE	INTERFACE	OPTIONS
  warp	WARP_IF		tcpflags,nosmurfs,routefilter=2,logmartians,physical=eth1.9
+ wg	WG_IF		physical=wg0

Then we define the wg zone…

# /etc/shorewall/zones
  #ZONE   TYPE    OPTIONS                 IN                      OUT
  #                                       OPTIONS                 OPTIONS
  warp    ipv4
+ wg      ipv4

Then we allow the warp zone to send packets to the wg zone.

# /etc/shorewall/policy
  #SOURCE	DEST		POLICY          LOGLEVEL        RATE    CONNLIMIT
- warp		$FW			ACCEPT          $LOG_LEVEL
+ warp		$FW,wg		ACCEPT          $LOG_LEVEL
Back to top